Autoscript Clock Plus LED Timecode Display

MSRP: $1,800.00

$1,620.00

SKU: Vitec-CLOCKPLUS Categories: ,

Description

The Autoscript Clock Plus LED Timecode Display allows you to view SMPTE/EBU timecode information and also changes color from green to red on application of a Tally input. Featuring 2.25” (5.71 cm) tall digits, the display supports HH:MM:SS A/P (hours / minutes / seconds, AM/PM) format in 12 or 24 hour mode.

The timecode input is obtained from the VITC (Vertical Interval Timecode) in the video input or from the LTC (Linear Timecode). An internal crystal oscillator enables the timecode display to continue updating the time, even if the timecode source is removed.

– For viewing SMPTE / EBU timecode information
– Application of a Tally input indicates color change (from green to red)
– Timecode input obtained from the VITC in the video input or from the LTC
– 2.25″ (5.71 cm) tall digits
– HH:MM:SS A/P (hours / minutes / seconds, AM/PM) format in 12 or 24 hour mode
– Instantly syncs with the input time when a time-code source is connected
– Internal crystal oscillator enables the timecode display to continue updating the time, even if the timecode source is removed

Specifications
Display Format: HH:MM:SS A/P
Size Size (HH:MM:SS): 2.25″ (A/P): 1.5″
Linear Time Code Input Standard: SMPTE 12M linear time code
24, 25 or 30 Fps nominal
Impedance: > 50k ø, balanced
Connector: 3 pin male TiniQ-G miniature XLR
Level: 1v to 3.0 p-p
Vertical Interval Time Standard: PAL or NTSC
Impedance: 75 ø, balanced
Connector: BNC socket
Code Input Level: 1v p-p
Tally Control Input Type: Logic signal, low = green
High (>2V) = red
Connector: 3.5 mm mono jack socket
Sleeve = ground, tip = signal
Opto Sensor Input Type: Light dependent resistor, 20k ø at
10 lux, 5K ø at 100 lux OR (grounding) contact closure

Reviews

There are no reviews yet.

Be the first to review “Autoscript Clock Plus LED Timecode Display”

Your email address will not be published. Required fields are marked *