Autoscript +TallyPlus+ Single Digit Tally Display

MSRP: $610.00


SKU: Vitec-TALLYPLUS Categories: ,


The +TallyPlus+ Single Digit Tally Display from Autoscript is a camera-numbering system and a tally indicator in one compact package. In live broadcast environments, it is essential that the talent to look into the right camera at the right time. This unit features a 2.25″ tall 7 segment LED indicator, which displays numbers from 0 to 9 in green when the camera is in standby mode and in red when the camera goes live, providing a definite visual cue to the presenter.

Designed to retrofit the entire Autoscript TFT range, the +TallyPlus+ switches from green to red via an internal sensor (photoelectric cell) that attaches to your camera tally (cue) light. It also features a second photoelectric cell built into the rear for uninterrupted operation.

The LED is powered via a 12 VDC power outlet directly on the prompter, although an external power source can be used if required. The lightweight (0.7 lb / 0.28 kg) +TallyPlus+ is easy to install and screws on to the front edge of your Autoscript TFT prompter.

Improved Camera Management

  • 2.25″ tall 7 segment LED indicator displays numbers from 0 to 9 green when the camera is in standby and red when live
  • Color change thanks to an built-in photoelectric cell

Docking Photoelectric Cell

  • A second photoelectric cell at the rear attaches to the cue light on the Autoscript TFT for uninterrupted operation in the event the primary cell fails


  • Lightweight and easy to install
  • Mounts directly to the front of the prompter — thumb screws in the unit mate with the threaded bosses on either side of the cue light on the front edge of the Autoscript monitor

Power and Integration

  • Retrofitted to work with any Autoscript TFT prompter
  • Powered via 12 VDC power outlet on the Autoscript prompter or an external power source
  • Works with +ClockPlus+ for displaying timecode information
Character Display 0 to 9
Size 2.25″ (5.72 cm)
Number Selection Rotary switch (rotate until the desired number 0 – 9 is shown on the display)
Sensor Trim Opto Sensor trim control – adjust for clean switching of internal or external opto sensor
Tally Signal Input Tally Signal Input Voltage: Senses a positive logic signal applied to the input and switches display red
Positive voltage (>2.5 V, < 12.5 V) = red, Voltage <1.0 V or contact open = green
Opto Sensor Input Resistance range: Light dependent resistor, 20 kohm at 10 Lux, 5 kohm, at 100 lux OR (grounding) contact closure < 1 kohm impedance
Power 12 V DC, 0.25 A
EMC Compatibility Standard: EN55022:1998 (+A1 / A2)
CFR 47 : 2004
Temperature Range Operating: 41 to 104° F (5 to 40° C)
Storage: -4 to 140° F (-20 to 60° C)
Dimensions (WxHxD) 2.36 x 3.23 x 1.22″ / 60 x 82 x 31 mm (excluding controls / connectors and wingplate)
Weight 0.33 lb / 0.15 kg


There are no reviews yet.

Be the first to review “Autoscript +TallyPlus+ Single Digit Tally Display”

Your email address will not be published. Required fields are marked *